Wiring removal and gauge refurbishment

Today was more wiring harness removal and working to get the relay, regulator, solenoid and gauges ready for re-installation with the new harness.  Some detail work but satisfying to see things clean up.

With the wiring mostly out I can get on to sound and heat reduction.  I will use some aluminum/butyl rubber (Raamat and some left over Dynamat).

I cleaned the knobs with simple green, then re-lettered with a white paint pen.
I wiped off the excess but did have to sand (1000 grit) some smeared white paint.  Then
I clear coated with an Eastwood clear coat.